Mitsubishi Electric MELDAS 60 Series Parameter Manual page 81

Error No.
P134 G96 Clamp Err.
The constant surface speed control
command (G96) was issued without
commanding the spindle speed clamp
(G92/G50).
P140 NO T-POS OFST
The position compensation command
(G45 to G48) specifications are not
available.
P141 PAT-ROT ERROR
Position compensation was commanded
during the figure rotation or coordinate
rotation command.
P142 T-OFFS G2 ERR
A position compensation invalid arc
command was commanded.
P150 NO R-CMP SPEC
• Even though there were no tool radius
compensation specifications, tool
radius compensation commands (G41
and G42) were issued.
• Even though there were no nose R
compensation specifications, nose R
compensation commands (G41, G42,
and G46) were issued.
P151 G2‚ 3 CMP. ERR
A compensation command (G40‚ G41‚
G42‚ G43‚ G44‚ G46) has been issued in
the arc mode (G02‚ G03).
P152 I.S.P NOTHING
In interference block processing during
execution of a tool radius compensation
(G41 or G42) or nose R compensation
(G41‚ G42‚ or G46) command‚ the
intersection point after one block is
skipped cannot be determined.
P153 I.F ERROR
An interference error has arisen while the
tool radius compensation command
(G41‚ G42) or nose R compensation
command (G41‚ G42‚ G46) was being
executed.
3. Program Error
Details
I - 67
Remedy
Press the reset key and carry out the remedy
below.
• Check the program.
• Issue the G92/G50 command before the G96
command.
• Command the constant surface speed cancel
(G97) to switch to the rotation speed
command.
(Applicable only to M65 V series and M64 C
version series)
• Check the specifications.
• Reconsider the program.
• Reconsider the program.
• Check the specifications.
• Issue the linear command (G01) or rapid
traverse command (G00) in the
compensation command block or cancel
block.
(Set the modal to linear interpolation.)
• Reconsider the program.
• Reconsider the program.