Mitsubishi Electric MELDAS 60 Series Parameter Manual page 421

13. Auxiliary Axis Parameter
Turn the NC power OFF after setting parameters indicated with a (PR) in the table. The setting will be
validated after the power is turned ON again.
No. Name
1 MSR Motor series
(PR)
2 RTY Regeneration
(PR) option type
3 PC1 Motor side
(PR) gear ratio
(machine
rotation ratio)
4 PC2 Machine side
(PR) gear ratio
(motor rotation
ratio)
5 PIT Feed pitch
(PR)
6 INP In-position
detection width
13. Auxiliary Axis Parameter
Details
Set the motor series. This is automatically judged
by the system when the default value (0000) is
set.
Set the regenerative resistor type. Do not set values without a description.
0 0 0 0 (Default value)
Setting
value
7~F
Set the No. of gear teeth on the motor side and
the No. of gear teeth on the machine side as an
integer reduced to its lowest terms.
Set the total gear ratio if there are multiple gear
levels.
For rotation axes, set the No. of motor rotation
speed per machine rotation.
Set 360 (default value) for rotation axes.
Set the feed lead for linear axes.
In-position is detected when the position droop
becomes this setting value or less.
II - 325
Amplifier standard built-in resistor (10CT
0
has no built-in resistor)
1 Setting prohibited
2 MR-RB032 (30W)
3 MR-RB12 (100W)
4 MR-RB32 (300W)
5 MR-RB30 (300W)
6 MR-RB50 (500W)
Default
Setting range
value
0000 to FFFF 0000
(hexadecimal)
Details
1 to 32767 1
1 to 32767 1
1 to 32767 360
(° or mm)
1 to 32767 50
(1/1000° or µm)