Mitsubishi Electric MELDAS 60 Series Parameter Manual page 167

# Items
ext07 Address
(bit1) specifying fixed
cycle repetition
count (For M
system only)
ext07 F-command unit Specify the unit to be used if a thread cutting read
(bit2)
ext07 G-code group
(bit3) for unidirectional
positioning (for
M system only)
ext07 Operation by
(bit4) independent
G40 command
ext07 Cut start position
(bit5) (For L system
only)
5. Base Specifications Parameters
Details
Specify the address that specifies the fixed cycle
repetition count. (Applicable only to M65 and M66)
0: Address L only
1: Addresses K and L
If addresses K and L are specified simultaneously,
the data at address K is used for operation.
command contains on decimal point. (Applicable
only to M65 and M66)
0: Type 1 (conventional specifications)
F1 → 1 mm/rev, 1 inch/rev
1: Type 2
F1 → 0.01 mm/rev, 0.0001 inch/rev
Specify the G-code group for unidirectional
positioning. (Applicable only to M65 and M66)
0: Unmodal G code (group 00)
1: Modal G code (group 01)
Related parameter: #8209 G60 SHIFT (Set the last
positioning direction and
distance for each axis
applicable when the
unidirectional positioning
command is issued.)
Specify the mode of canceling radius compensation
vector by the independent G40 command.
(Applicable only to M65 and M66)
0: Type 1 (conventional specifications)
The independent G40 command cancels the
radius compensation vector.
1: Type 2
The radius compensation vector is not
canceled by the independent G40 command
but is canceled by the next move command
for the radius compensation plane.
Specify the position from where cutting begins in a
fixed cycle for compound lathe.
0: Conventional specifications
The cut start position is determined by the
final shaping program.
1: Extended specifications
The cut start position is determined from the
cycle start point.
II - 71
Setting range (unit)
0/1
(Default: 0)
0/1
(Default: 0)
0/1
0/1
(Default: 0)
(Default: 0)
0/1
(Default: 0)