Mitsubishi Electric MELDAS 60 Series Parameter Manual page 174

# Items
1285 ext21 Multi-system
(PR) (bit0) program
generation and
operation
ext21 Changeover of
(bit1) method to select
operation
program
1286 ext22 Program
(PR) (bit0) input/output
method selection
ext22
(bit1)
ext22 0 No. for
(bit2) program input
No.
ext22 No 0 No. at
(bit3) machining
program input
1287 ext23 Workpiece
(PR) (bit0) coordinate
display
5. Base Specifications Parameters
Details
0: When a machining program is newly
registered, it is registered as a program for
the selected system.
1: When a program is newly registered, a
system common program No. is generated
unconditionally. If there are no contents in the
subprogram when a subprogram is called
during automatic operation, the program will
be searched for and executed from $1.
0: Select the program in the selected system
with operation search.
1: Select a common system program with
operation search. (A common system
program No. will be selected.)
0: Only the programs in the selected system are
input/output.
1: The designated programs are output for all
systems. The systems are delimited with the
"$" mark. The programs delimited with the
$ mark are assigned and input into each
system. (If the program does not have a
$ mark, it will be handled as system 1.)
Not used.
Select the action to be taken when the same
program No. is input during data input.
0: The 0 No. when the same 0 No. is input
successively is handled as a character string
data.
1: The 0 No. is handled as a program No. when
the same 0 No. is input successively.
Whether to overwrite the program or cause
an error is set with #1218 bit 7 "Input by
program overwrite".
This setting enables the machining program input
even if there is no program No. (0 No.).
The program No. is fixed to 01 in this case.
0: Input disabled
1: Input enabled
Select the mode of displaying the workpiece
coordinate counter.
0: Don't update the display immediately after
workpiece coordinate data is changed.
1: Update the display immediately after
workpiece coordinate data is changed.
II - 78
Setting range (unit)
0/1
0/1
0/1
0/1
0/1
0/1