Mitsubishi Electric MELDAS 60 Series Parameter Manual page 183

# Items
1534 SnG44.1 Spindle No. for
G44.1
command
1535 C_leng Minimum
turning
movement
amount
1537 crsax[1] Cross
to to machining
1544 crsax[8] control axis
# Items
1549 Iv0vr1 Override 1 start
curvature radius
1550 Iv0vr2 Override 2 start
curvature radius
1551 Iv0vr3 Override 3 start
curvature radius
1552 Iv0vr4 Override 4 start
curvature radius
1553 Iv0vr5 Override 5 start
curvature radius
1554 Iv0rd2 Involute
interpolation
override 2
5. Base Specifications Parameters
Details
Set the selected spindle No. for the G44.1
command.
#1199 #1534
0:G43.1 Not used.
1:G44.1 0
1
2
3
4
2:G47.1 Not used.
Set the minimum turning movement amount of the
normal line control axis at the block joint during
normal line control.
Set the axis to be interchanged during cross
machining control.
Using two digits, set the name of the axis
interchanged with that where the cross machining
control request signal is input, or that moves to the
position where the signal is input.
(SETUP PARAM 1. 12/15)
Details
Set the override 1 start curvature radius for
executing involute interpolation with the high-speed
high-accuracy II mode.
Set the override 2 start curvature radius for
executing involute interpolation with the high-speed
high-accuracy II mode.
Set the override 3 start curvature radius for
executing involute interpolation with the high-speed
high-accuracy II mode.
Set the override 4 start curvature radius for
executing involute interpolation with the high-speed
high-accuracy II mode.
Set the override 5 start curvature radius for
executing involute interpolation with the high-speed
high-accuracy II mode.
Set the override value at the curvature radius
Iv0vR2 for executing involute interpolation with the
high-speed high-accuracy II mode.
Note: If the override value is not set (setting value:
0), the setting will be invalid, and the override
will be 100%.
II - 87
Selected spindle
1st spindle
2nd spindle
1st spindle
2nd spindle
3rd spindle
4th spindle
All spindles
Setting range (unit)
0: 2nd spindle
1: 1st spindle
2: 2nd spindle
3: 3rd spindle
4: 4th spindle
If a spindle that does
not exist is set, the
2nd spindle will be
used. Note that if
there is only one
spindle, the 1st
spindle will be used.
0.000 to 99999.999
(mm)
Two digits between A
to Z and 1 to 9
(Setting is cleared
when 0 is set)
Setting range (unit)
0.001 to 99999.999
(mm)
0.001 to 99999.999
(mm)
0.001 to 99999.999
(mm)
0.001 to 99999.999
(mm)
0.001 to 99999.999
(mm)
1 to 100 (%)