Mitsubishi Electric MELDAS 60 Series Parameter Manual page 392

No. Items
3407 SP207 GDL
3408 SP208 W2
3409 SP209
to to
3413 SP213
3414 SP214 TZRN
3415 SP215 TPDT
3416 SP216 TPST
8. Spindle Parameters
8.4 MDS-C1-SPM
Sequential To carry out spindle synchronization or C-axis
mode startup control in the both-chuck state with no
timing movement immediately after the power is
turned ON, set this parameter so that the
reverse run detection function will function
correctly. Set so that servo ON timing for the
opposing spindle has the combination of (1)
and (2) shown in the drawing below.
0: Servo turns ON simultaneously with servo
ON command, and servo ON status is
returned immediately.
1: Gate turns ON at pattern (1) shown below,
and servo ON status is returned two
seconds later.
2: Gate turns ON at pattern (2) shown below,
and servo ON status is returned two
seconds later.
Servo ON command
Servo ON (1)
Servo ON (2)
Servo ON status
This is used by Mitsubishi.
Set to "0" unless particularly designated.
Not used. Set to "0".
Synchronized This parameter is valid when SP193 (SPECT)
tapping bitE is set to "0".
zero point Set the zero point return speed used when
return speed the speed loop changes to the position loop.
Synchronized This parameter is valid when SP193 (SPECT)
tapping bitE is set to "0".
zero point Set the deceleration rate where the machine
return starts to decelerate when it returns to the
deceleration
target stop point during synchronized tapping
rate zero point return.
When the machine tends to overshoot at the
stop point set a smaller value.
Synchronized This parameter is valid when SP193 (SPECT)
tapping bitE is set to "0".
zero point Set the synchronized tapping zero point
return shift position.
amount
Details
Gate ON
700ms
300ms
II - 296
Setting
range
0/1/2 0
Servo ON
300ms
Gate ON
700ms
2s
0 0
0 0
0 to 10000 1
(pulse)
0 to 4095 0
Standard
setting