Mitsubishi Electric MELDAS 60 Series Parameter Manual page 120

# Items
1016 iout Inch output
(PR)
1017 rot Rotational
(PR) axis
1018 ccw Motor CCW
(PR)
1019 dia Diameter
(PR) specification
axis
1020 sp_ax Spindle
(PR) Interpolation
1021 mcp_no Amplifier I/F
(PR) channel No.
(servo)
1022 axname2 2nd axis
(PR) name
5. Base Specifications Parameters
Details
Specify whether the machine system (ball screw
pitch‚ position detection unit) is an inch unit system
or metric unit system.
Specify whether the axis is a rotary axis or linear
axis.
For the rotary axis‚ the position display will be 360°‚
and the axis will return to 0°.
If the position display is to be continuously
displayed even with the rotary axis‚ set the axis as a
linear axis
Specify the direction of the motor rotation to the
command direction.
0: Rotates clockwise (looking from motor shaft)
with the forward rotation command.
1: Rotates counterclockwise (looking from
motor shaft) with the forward rotation
command.
Specify whether the program movement amount is
to be commanded with the diameter dimension or
as movement amount.
When the movement amount is commanded with
the diameter dimensions‚ 5mm will be moved when
the command is a movement distance of 10mm.
The movement amount per pulse will also be
halved during manual pulse feed.
Among parameters concerning length‚ the tool
length‚ the wear compensation amount and the
workpiece coordinate offset are displayed in
diameter value when diameter is specified‚ but
other parameters are always displayed in radius
value.
Specify 1 when the NC control axis is used as the
spindle.
Using a 4-digit number, set the amplifier interface
channel No. and which axis in that channel is to be
used when connecting an axis amplifier.
High-order two digits : Amplifier interface channel
No.
Low-order two digits : Axis No.
When using the conventional fixed layout, set all
axes to "0000".
Set the name of the axis displayed on the screen
with two characters. (X1, Z2, etc.)
II - 24
Setting range (unit)
0: Metric unit
system
1: Inch unit system
0: Linear axis
1: Rotary axis
0: Rotates clockwise
1: Rotates counter-
clockwise
0: Command with
movement amount
1: Command with
diameter dimension
0: The NC control axis
is used as the servo
axis.
1: The NC control axis
is used as the
spindle.
0000
0101 to 0107
0201 to 0207
Two digits between A to
Z and 1 to 9 (Setting is
cleared when 0 is set)