Mitsubishi Electric MELDAS 60 Series Parameter Manual page 383

No. Items
3331 SP131 PGC2
3332 SP132 PGC3
3333 SP133 PGC4
3334 SP134 VGCP0∗ C-axis
(PR)
3335 SP135 VGCI0
(PR)
3336 SP136 VGCD0
(PR)
3337 SP137 VGCP1
(PR)
3338 SP138 VGCI1
(PR)
3339 SP139 VGCD1
(PR)
3340 SP140 VGCP2
(PR)
3341 SP141 VGCI2
(PR)
3342 SP142 VGCD2
(PR)
8. Spindle Parameters
8.4 MDS-C1-SPM
Second position Set the position loop gain when the
loop gain for second gain is selected for C axis
cutting on C-axis cutting.
Third position Set the position loop gain when the
loop gain for third gain is selected for C-axis
cutting on C-axis cutting.
Stop position Set the position loop gain for
loop gain for stopping when carrying out C-axis
cutting on C-axis cutting.
Set the speed loop proportional gain
non-cutting in C-axis non-cutting mode.
speed loop gain
proportional item
C-axis Set the speed loop integral gain in
non-cutting C-axis non-cutting mode.
speed loop gain
integral item
C-axis
Set the speed loop delay advance
non-cutting gain in C-axis non-cutting mode.
speed loop gain When this parameter is set to "0", PI
delay advance control is exercised.
item
First speed loop Set the speed loop proportional gain
gain proportional when the first gain is selected for
item for C-axis C-axis cutting.
cutting
First speed loop Set the speed loop integral gain
gain integral item when the first gain is selected for
for cutting on C-axis cutting.
C-axis
First speed loop
Set the speed loop delay advance
gain delay gain when the first gain is selected
advance item for for curing on the C-axis.
cutting on C-axis When this parameter is set to "0", PI
control is applied.
Second speed Set the speed loop proportional gain
loop gain when the second gain is selected for
proportional item C-axis cutting.
for cutting on
C-axis
Second speed Set the speed loop integral gain
loop gain integral when the second gain is selected for
item for cutting C-axis cutting.
on C-axis
Second speed Set the speed loop delay advance
loop gain delay
gain when the second gain is
advance item for selected for C-axis cutting.
cutting on C-axis When this parameter is set to "0", PI
control is applied.
Details
II - 287
Setting Standard
range setting
1 to 200 15
(1/s)
1 to 200 15
(1/s)
1 to 200 15
(1/s)
0 to 5000 63
(1/s)
0 to 5000 60
(0.1 1/s)
0 to 5000 15
(0.1 1/s)
0 to 5000 63
(1/s)
0 to 5000 60
(0.1 1/s)
0 to 5000 15
(0.1 1/s)
0 to 5000 63
(1/s)
0 to 5000 60
(0.1 1/s)
0 to 5000 15
(0.1 1/s)