Mitsubishi Electric MELDAS 60 Series Parameter Manual page 202

# Items
2071 s_axis Inclined axis
(For L selection
system
only)
2072 rslimt Restart limit
6. Axis Specifications Parameters
6.4 Axis Specifications Parameters 2
Select the axis subjected to inclined-axis control or the
base axis corresponding to the inclined axis.
0: Axis not subjected to inclined-axis control
1: Inclined axis
2: Base axis corresponding to inclined axis
Note: Set 1 or 2 for only one axis. If it is set for two or
more axes, inclined-axis control does not work.
If the machine is positioned on the minus (-) side of the
set value in T-command restart mode, restart search in
type 3 is disabled.
II - 106
Details Setting range (unit)
0 to 2
±9999.999 (mm)