Mitsubishi Electric MELDAS 60 Series Parameter Manual page 130
Cnc
Hide thumbs
Also See for MELDAS 60 Series:
- Maintenance manual (323 pages) ,
- Programming manual (322 pages)
Advertisement
#
Items
1073 I_Absm
Initial
absolute
value
1074 l_Sync
Initial
synchronous
feed
1075 I_G00
Initial G00
1076 Abslnc
ABS/INC
(For L
address
system
only)
1077 radius
Incremental
command for
diameter
specification
axis
1078 Decpt2
Decimal point
type 2
1079 F1digt
Validate F1
digit
1080 Dril_Z
Specify boring
(For D
axis
system
only)
5. Base Specifications Parameters
(SETUP PARAM 1. 4/15)
Details
Specify the absolute value/incremental value
mode for when the power is turned ON or reset.
Specify the feedrate specification mode for when
the power is turned ON or reset.
0: Asynchronous feed (feed per minute)
1: Synchronous feed (feed per rotation)
Specify the linear command mode for when the
power is turned ON or reset.
0: Linear interpolation (G01 command state)
1: Positioning (G00 command state)
The absolute value/incremental commands can
be issued by using the absolute value address
and incremental value address for the same axis.
0: Absolute/incremental with G command
1: Absolute/incremental with address code
(The #1013 axname address will be the
absolute value command‚ and #1014 incax
address will be the incremental value
command)
Specify if the diameter specification axis' (#1019
dia is set to 1) incremental value command uses
the diameter value or radius value
Specify the unit of position commands that do not
have a decimal point.
0: The min. input command unit is used
(follows #1015 cunit)
1: 1mm (or 1inch) unit is used
(For the dwell time, 1s unit is used.)
Specify whether to execute the F command with a
1-digit code command or with a direct numerical
command.
0: Direct numerical command (command
feedrate during feed per minute or rotation)
1: 1-digit code command (feedrate specified
with #1185 spd_F1 – #1189 F5)
Specify a fixed cycle hole drilling axis.
0: Use an axis vertical to the selected plane as
the hole drilling axis.
1: Use the Z axis as the hole drilling axis
regardless of the selected plane.
II - 34
Setting range (unit)
0: Incremental value
command mode
1: Absolute value
command mode
0: Asynchronous
feed
1: Synchronous feed
0: Linear
interpolation
1: Positioning
0: Absolute/
incremental with G
command
1: Absolute/
incremental with
address code
0: Diameter value
1: Radius value
0: The min. input
command unit is
used
1: 1mm (or 1inch)
unit is used
0: Direct numerical
command
1: 1-digit code
command
0/1
Advertisement
