Mitsubishi Electric MELDAS 60 Series Parameter Manual page 131

# Items
1081 Gmac_P Give priority
to G code
parameter
1082 Geomet Geometric
(For L
system
only)
1084 RadErr Arc error
1085 G00Drn G00 dry run Specify whether to apply dry run (feed with manual
1086 G0lntp G00
non-interpol
ation
1087 G96_G0 Constant
surface
speed
control by
rapid
traverse
feed
command
1088 G30SL Disable G30
soft limit
1089 Cut_RT Short cut for
rotary axis
5. Base Specifications Parameters
Details
Specify the G code priority relationship during the
macro call with the G command.
0: G code used in system is priority.
1: Registered G code for call out is priority.
Specify whether to use the geometric I or IB
function.
0: Do not use.
1: Use only geometric I.
2: Use geometric I and IB.
With geometric, specific address codes are used for
exclusive meanings. Thus, if A or C is used for the
axis address or 2nd miscellaneous command code,
the A used for the axis address may function as the
geometric's angle designation. Take special care
when designating the axis name, etc., when using
this function.
Specify the tolerable error range when a deviation
occurs in the end point and center coordinate in the
circular command.
setting speed instead of command feedrate) to the
G00 command.
0: Do not apply to G00. (move at rapid traverse
rate)
1: Apply to G00. (move at manual set feedrate)
Specify the G00 movement path type
0: Move linearly toward the end point.
(interpolation type)
1: Move to the end point of each axis at the rapid
traverse feedrate for each axis.
(non-interpolation)
Specify how to handle the cycle speed for the G00
command when using the constant surface speed
control function.
0: Calculate the cycle speed constantly even
during G00 movement.
1: Calculate the cycle speed at the block end
point in the G00 command.
Specify how to handle the soft limit during G30 (2nd
reference point return) movement.
0: Soft limit valid during G30 movement
1: Soft limit invalid during G30 movement
Specify how to handle the short cut control for the
rotary axis (#1017 rot is set to 1).
0: No short cut (move toward end point)
1: Use short cut (when using the absolute value
command‚ move in the direction where the
movement amount will be 180° or less)
II - 35
Setting range (unit)
0/1
0/1/2
0 to 1.000 (mm)
0: Do not apply to
G00
1: Apply to G00
0/1
0/1
0: Soft limit valid
1: Soft limit invalid
0: No short cut
1: Use short cut