Mitsubishi Electric MELDAS 60 Series Parameter Manual page 145

# Items
1181 G96_ax Constant
surface
speed
control
1182 thr_F Thread
cutting
speed
1183 clmp_M M code for
clamp
1184 clmp_D Dwelling
time after
outputting
M code for
unclamp
F1 digit
feedrate
spd_F1 F1
1185
1186 spd_F2 F2
1187 spd_F3 F3
1188 spd_F4 F4
1189 spd_F5 F5
1190 s_xcnt Validate
(PR) (For L inclined-
system axis control
only)
1191 s_angl Inclination
(PR) (For L angle
system
only)
1192 s_zrmv Compensa
(PR) (For L tion at
system origin
only) return
5. Base Specifications Parameters
Details
Specify the axis to be targeted for constant surface
speed control.
0: Program specification will be invalidated‚ and
the axis will always be fixed to the 1st axis.
1: 1st axis specification
2: 2nd axis specification
3: 3rd axis specification
: :
8: 8th axis specification
The program specification will be the priority for all
settings other than 0.
Set the screw cut up speed when not using
chamfering in the thread cutting cycle.
0: Cutting feed clamp feedrate
1 to 60000 mm/min: Set feedrate
Set the M code for C-axis clamp in the hole drilling
cycle.
Set the dwell time after outputting the M code for
C-axis unclamp in the hole drilling cycle.
Specify the feedrate for the F command in the
F1-digit command (#1079 F1 digt is set to 1).
Feedrate when F1 is issued (mm/min)
Feedrate when F2 is issued (mm/min)
Feedrate when F3 is issued (mm/min)
Feedrate when F4 is issued (mm/min)
Feedrate when F5 is issued (mm/min)
Specify whether to disable or enable inclined-axis
control.
0: Disable inclined-axis control
1: Enable inclined-axis control
Specify the inclination angle (
Note: If 0 is specified for this parameter, the angle
determined by three-side setting is valid.
Specify whether to perform compensation for the
base axis corresponding to the inclined axis at
original return.
0: Perform compensation.
1: Don't perform compensation.
II - 49
θ
).
Setting range (unit)
0 to 8
0 to 60000 (mm/min)
0 to 99999999
0.000 to 99999.999 (s)
1 to 60000 (mm/min)
0/1
± 80.000 (°)
0/1