Mitsubishi Electric MELDAS 60 Series Parameter Manual page 136

# Items
1114 mcrint Macro
argument
initialization
1115 thwait Waiting for
thread
cutting
1116 G30SLM Invalidate
soft limit
(manual
operation)
1117 H_sens Handle
response
switch
1118 mirr_A Select how
(For L to set up the
system length of
only) tools on
cutter tables
(opposed
tables)
1119 Tmiron Select the
(For L mirror image
system of each
only) facing turret
with T
command
1120 TofVal Change
(PR) macro
variable
5. Base Specifications Parameters
Details
Select whether to clear statements other than
specified arguments by macro call. Also, select
whether to clear local variables by power-ON and
resetting.
0: Delete non-specified arguments by macro
call.
1: Retain non-specified arguments by macro
call.
2: Retain non-specified arguments by macro
call and clear local variables by power-ON
and resetting.
Set the queue number during screw thread cutting
when the chamfering is not valid.
Enable this function when disabling the soft limit
check function from the second to the fourth zero
point return by manual operation.
Switch the handle response mode when feeding
the handle.
0: Standard handle response
1: High-speed handle response
Select one of the following two methods:
• Set up the current length of tools on each
facing turret.
• Set up a value, assuming that the tools on
each facing turret are in the same direction
as that of those on the base turret.
0: Current length of the tools on each facing
turret
1: Value, assuming that the tools on each
facing turret are in the same direction as that
of those on the base turret.
Select whether to validate the mirror image of each
facing turret with the T command.
Specify whether to change the macro variable (tool
offset) numbers for shape compensation and wear
compensation.
0: Do not change. (Conventional
specifications)
1: Change the shape and wear compensation
variable numbers each for X, Z, and R.
II - 40
Setting range (unit)
0/1/2
0 to 99
(Approx. 4 ms.)
Standard set value: 4
0: Enable soft limit
function.
1: Disable soft limit
function.
0/1
0/1
0: Invalid
1: Valid
0/1