Mitsubishi Electric MELDAS 60 Series Parameter Manual page 71

Error No. Error message
E201 UNIT NOT EQUIP
E301 CONNECT
ERROR
E302 LOGIN ERR
E303 TIME OUT
E311 DOWNLOAD ERR
E312 UPLOAD ERR
E313 NO FILE
E314 FILE DUPLICATE
E315 FILE WRITE ERR
E316 FILE READ ERR
E317 MEMORY OVER
E318 OVER FLOW ERR
E319 DIRECTORY ERR
E320 HR437
UNEQU
2. Operation Messages on Setting And Display Unit
2.1 Operation Errors
×
• The analog output unit is not mounted.
• Confirm the remote l/O unit.
• Prepare a unit having analog output.
• Check the connection (power and signal wires)
• Unit defect (replace unit)
×
• A socket connection attempt failed during Ethernet
communication.
• Check the host address, the setting of the port No. and that the
host computer is turned ON.
×
• A login attempt failed during Ethernet communication. Check the
user name and password.
• Check the account settings, such as the home directory.
×
• Transmission of a file with Ethernet communication ended
because of timeout.
×
• An attempt to read a host file failed during Ethernet
communication.
×
• An attempt to write to a host file failed during Ethernet
communication.
× • The file specified by host receive (host → IC) operation during
Ethernet communication is not found in the host.
• The file specified by host send (IC → host) operation during
Ethernet communication is not found in the IC card.
× • The file name specified to be stored by host receive (host → IC)
operation during Ethernet communication already exists in the IC
card.
• The file name specified to be loaded by host send (IC → host)
operation during Ethernet communication already exists in the
host.
×
• An attempt to write to the IC card failed during Ethernet
communication.
×
• An attempt to read a file from the IC card failed during Ethernet
communication.
×
• IC card memory is full.
• NC memory is full.
×
• A host directory contains too many files.
×
• An attempt to move a directory failed.
• In the IC card device, accessing a directory in the nineteenth
layer or more was attempted.
×
• When backup or writing of the expansion cassette into/from the
FROM, the expansion cassette (HR437) was not mounted in
CBUS#1 or was incorrectly mounted.
• When backup or writing of the expansion cassette into/from the
FROM, a card other than the expansion cassette (HR437) was
mounted in CBUS#1.
• When the program memory was formatted to 1280m or more, the
expansion cassette (HR437) was not mounted in CBUS#1.
Details
I - 57