Mitsubishi Electric MELDAS 60 Series Parameter Manual page 381

No. Items
3321 SP121 MPCSH Orientation
3322 SP122 MPCSL
3323 SP123
to to
3325 SP125
3326 SP126 MPGH
3327 SP127 MPCSM Orientation
3328 SP128 OXKPM Position
8. Spindle Parameters
8.4 MDS-C1-SPM
Set the compensation magnification of the
deceleration orientation deceleration rate for the H winding.
rate H
winding Orientation deceleration rate for the H
compensa- winding
tion magnifi- = SP006 × SP121/256
cation
When set to "0", will become the same as
SP006.
Orientation Set the compensation magnification of the
deceleration orientation deceleration rate for the L winding.
rate L
winding Orientation deceleration rate for the L
compensa- winding
tion magnifi- = SP006 × SP122/256
cation
When set to "0", will become the same as
SP006.
Use not possible.
Orientation Set this to set the orientation position loop
position gain gain for the coil changeover motor to the M
M coil com- coil's unique value.
pensation
Set this to set the orientation deceleration rate
deceleration for the coil motor to the M coil's unique value.
rate M coil
compensa-
tion
Set the M coil gain magnification to be used
loop gain after in-position when gain changeover is
magnifi- valid (SP097: SPEC0-bitC=1) during
cation after orientation.
orientation
gain
change-
over (M coil)
Details
II - 285
Setting Standard
range setting
0 to 2560 0
(1/256-fol
d)
0 to 2560 0
(1/256-fol
d)
0 0
0 to 2560 0
(1/256-
fold)
0 to 2560 0
(1/256-
fold)
0 to 2560 0
(1/256-
fold)