Mitsubishi Electric MELDAS 60 Series Parameter Manual page 188

6. Axis Specifications Parameters
6.1 Axis Specifications Parameters
After setting up the parameter (PR) listed in the table, turn OFF the NC power. To validate the parameter,
turn ON the power again.
# Items
2001 rapid Rapid traverse
rate
2002 clamp Cutting feedrate
for clamp
function
2003 smgst Acceleration and
(PR) deceleration
modes
6. Axis Specifications Parameters
6.1 Axis Specifications Parameters
(SETUP PARAM 2. 1/8)
Details
Set up the rapid traverse feedrate for each axis.
The maximum value to be set differs with
mechanical systems.
Define the maximum cutting feedrate for each axis.
Even if the feedrate in G01 exceeds this value‚ the
clamp will be applied at this feedrate.
Specify acceleration and deceleration control
modes.
F E D C B A 9
O T3 O T2 O T1 C 3
Note: Set 0 in null bits. (Bit2 and bit6 when the
acceleration/deceleration by software is selected
are excluded.)
Rapid traverse feed acceleration and
deceleration types
LR Linear acceleration/
R1 Primary delay
R3 Exponential acceleration
bit0 to 3 ON Acceleration/
Cutting feed acceleration and deceleration types
LC Linear acceleration/
C1 Primary delay
C3 Exponential acceleration
bit4 to 7 ON Acceleration/
(To be continued to the next page)
II - 92
8 7 6 5 4 3 2 1
C 1 L C R 3 R 1
deceleration
and linear deceleration
deceleration by software
deceleration
and linear deceleration
deceleration by software
Setting range (unit)
1 to 999999 (mm/min)
1 to 999999 (mm/min)
Specify the modes in
hexadecimal notation.
0
L R