Mitsubishi Electric MELDAS 60 Series Parameter Manual page 164

# Items
1238 set10 Switch G36
(PR) (bit0) function
set10
(bit6)
set10 Switch operation
(bit7) alarm
1239 set11 Coil switching
(PR) (bit0) method
set11
(bit1)
set11
(bit2)
set11 Polygon
(bit3) machining mode
at reset
set11 Invalidate G51.1
(bit4) phase command
5. Base Specifications Parameters
Details
If a G code system containing the G36 (automatic
tool length measurement X) function is selected,
select whether to use G36 for the automatic tool
length measurement or arc thread cutting (CCW)
function.
0: Automatic tool length measurement
1: Arc thread cutting (CCW)
Not used.
Select whether to validate the NC alarm 5 (AL5)
signal output.
0: NC alarm 5 (AL5) invalid
All operation alarms are output to NC alarm 4
(AL4).
All operation alarms are recorded in the
alarm history.
1: NC alarm 5 (AL5) valid
The following operation alarms are not output
to NC alarm 4 (AL4). These are output to NC
alarm 5 (AL5).
The operation alarms output to NC alarm 5
(AL5) are not recorded in the alarm history.
• External interlock axis found
• Cutting override zero
• External feedrate zero
• Block start interlock
• Cutting block start interlock
• Cutting interlock for spindle-spindle
polygon (G51.2)
0: Via PLC. (Y2D7)
1: NC internal processing. (Y2D7 is invalid.)
Not used.
Not used.
Select whether to cancel the polygon machining
mode when reset is applied.
0: Do not cancel.
1: Cancel.
Select whether to carry out phase control with the
spindle-spindle polygon function.
0: Always validate phase control.
* When R is not commanded, it is handled as
R0.
1: Validate phase control only at R command
II - 68
Setting range (unit)
0/1
0/1
0/1
(Default: 0)
0/1
0/1
0/1
0/1
0/1