Mitsubishi Electric MELDAS 60 Series Parameter Manual page 377

No. Items
3276 SP076 FONS Machine
3277 SP077 TDSL
(PR)
3278 SP078 FPWM Fixed control
(PR)
3279 SP079
3280 SP080 SWTD Fixed control
3281 SP081
to to
3286 SP086
3287 SP087 DIQM
(PR)
3288 SP088 DIQN
(PR)
3289 SP089
to to
3292 SP092
3293 SP093 ORE
(PR)
3294 SP094 LMAV Load meter
(PR)
3295 SP095 VFAV
(PR)
8. Spindle Parameters
8.4 MDS-C1-SPM
When the vibration increases in motor stop
resonance (ex. in orientation stop) when the machine
suppression vibration suppression filter is operated by
filter SP070, operate the machine vibration
operation suppression filter at a speed of this parameter
speed or more.
When set to "0", this is validated for all speeds.
Fixed control Set by Mitsubishi.
constant Set "14" unless designated in particular.
Set by Mitsubishi.
constant Set "1" unless designated in particular.
Use not possible.
Set by Mitsubishi.
constant Set "0" unless designated in particular.
Use not possible.
Target value Set the minimum value of variable torque limit
of variable at deceleration.
torque limit
magnifica-
tion at
deceleration
Speed for Set the speed where the torque limit value at
starting deceleration starts to change.
change of
variable
torque limit
100%
magnifica-
tion at
deceleration
SP087
Use not possible.
Tolerable Set this when detecting the pulse detector's
pulse check pulse mistakes.
error (Valid only for full close control.)
Set the filter time constant of load meter
output filter output.
When "0" is set, a filter time constant is set to
100ms.
Fixed control Set by Mitsubishi.
constant Set "0" unless designated in particular.
Details
Torque limit
Inversely proportional
to speed
Speed
SP088 SP017
II - 281
Setting Standard
range setting
0 to 32767 0
(r/min)
14
1 1
0 0
0 0
0 0
0 to 150 75
(%)
0 to 32767 3000
(r/min)
0 0
0 to 32767 0
0 to 32767 0
(2ms)
0 0