Mitsubishi Electric MELDAS 60 Series Parameter Manual page 68

Error No. Error message
E62 I/O PARAM ERR
E64 PROGRAM No.
ERR
E65 PROG. No. DUPLl
E66 NO PROG.
NUMBER
E69 PROG. CHECK
MODE
E70 TOOL No. DUPLl
E71 TOOL ENTRY
OVER
E73 CAN'T
CALCULATE
E74 MENU
IMPOSSIBLE
2. Operation Messages on Setting And Display Unit
2.1 Operation Errors
∆
• The "EIA code" data set for I/O parameter is of an unusable
code.
• The unusable codes are those used as the EIA standard codes
and the even hole codes.
• System configuration data output operation was executed
without using the data ASCII. Set "0" to EIA output, "1" to data
ASCII in the I/O device parameters.
∆
• The same No. as the program No. designated for program copy
was found in the memory.
• During tape input‚ the first character of the machining program
block is the program No. address "O" or "L".
∆
• During tape input‚ the same No. as the specified program was
found in the memory.
∆
• During tape input‚ the program No. was not found on the paper
tape‚ and a program No. was not designated on the screen's
data setting area. Set the program No.‚ and input again.
×
• Search (operation search) was attempted during program check
(continuous or step).
• Retry search after the program check is completed‚ or after
resetting the program search
∆
• A tool No. already registered was newly registered on the tool life
management screen.
×
• Registration of data exceeding the max. No. of registerable tools
was attempted on the tool life management screen.
• When inputting the tool offset data onto tape‚ a compensation
number exceeding the specifications range was specified‚ and
that block could not be input. If the INPUT key is pressed again in
the input screen, the input will continue from the next block.
×
• The coordinate value of the hole center cannot be obtained.
• Reset the measurement point, which must not applied to the
following conditions.
The measurement A point is the same as the Y coordinate of
the C point.
The measurement B is the same as the Y coordinate of the C
point.
The slope of the line through A and C point is the same as the
slope of the line through B and C point.
×
• Press the operation menu "= Input" or "+ input" during the tool
measurement.
• Press the operation menu "= Input" or "+ input" during the
manual value command mode.
• Press the screen selection menu on which "↓" is displayed
during the tool measurement.
• Press the screen selection menu on which "↓" is displayed
during the manual value command mode.
Details
I - 54