Mitsubishi Electric MELDAS 60 Series Parameter Manual page 168

# Items
ext07 Nose R
(bit6) compensation
(For L system
only)
ext07 Cut amount (For
(bit7) L system only)
1272 ext08 Switch pocket
(PR) (bit0) machining
operation
ext08 M function
(bit1) synchronous tap
cycle
ext08 Spiral/conical
(bit2) interpolation
command format
2
ext08 Switch macro
(bit3) call function
5. Base Specifications Parameters
Details
Specify whether to apply nose R compensation to
shapes in a rough cutting cycle.
0: Conventional specifications
If nose R compensation is enabled for the
final shaping program, the shape obtained
after applying nose R compensation to the
final shaping program is used as the rough
cutting shape.
1: Extended specifications
The shape made by the final shaping
program, without nose R compensation, is
used as the rough cutting shape.
Specify the operation to be performed when the
program-specified cut amount exceeds the cut
amount of the final shaping program.
0: Conventional specifications
A program error occurs if the
program-specified cut amount exceeds the
cut amount of the final shaping program.
1: Extended specifications
Rough cutting is performed by one cut if the
program-specified cut amount exceeds the
cut amount of the final shaping program.
0: Conventional specifications
Pocket machining is selected with the H
designation.
The pull direction when pocket machining is
ON is the Z direction.
1: Extended specifications
If there is an X and Z axis in the first
movement block after the finished shape start
block is started, pocket machining will start.
The pull direction when pocket machining is
ON is the X direction.
Specify whether to enable the M function
synchronous tap cycle.
0: Invalid
1: Valid
Select the command format for spiral interpolation
and conical interpolation.
0: Type 1 (conventional specifications)
1: Type 2 (spiral speed L designation, increment
designation)
Select whether to shift the argument to the
subprogram if nests are overlapped when per block
call (G66.1) is commanded.
0: Shift argument even if nests are overlapped.
1: Do not shift arguments if nests differ.
(Conventional specifications)
II - 72
Setting range (unit)
0/1
(Default: 0)
0/1
(Default: 0)
0/1
0/1
0/1