Mitsubishi Electric MELDAS 60 Series Parameter Manual page 357

No. Items
3380 SP180 VGSD
(PR)
3381 SP181 VCGS
(PR)
3382 SP182 VCSS
(PR)
3383 SP183 SYNV
3384 SP184 FFCS
(PR)
3385 SP185 SINP
3386 SP186 SODR
(PR)
3387 SP187 IQGS
(PR)
8. Spindle Parameters
8.3 MDS-B-SP/SPH, MDS-C1-SP/SPH
Spindle Set the speed loop delay advance gain in
synchronous spindle synchronous mode.
speed loop When this parameter is set to "0", PI control
gain delay is applied.
advance term
Spindle Set the magnification of speed loop
synchronous proportional gain with respect to SP178
Target value of (VGSP) at the maximum speed defined in
variable speed SP017 (TSP) in spindle synchronous mode.
loop
proportional
gain
Spindle Set the speed when the speed loop
synchronous proportional gain change starts in the
Change spindle synchronous mode.
starting speed
of variable
speed loop
proportional
gain
SP178×
(SP181/100)
Spindle For changeover from the speed loop to the
synchronous position loop in the spindle synchronous
Sync match- mode, set a speed command error range for
ing speed output of the synchronous speed matching
signal.
Spindle Set the acceleration rate feed forward gain in
synchronous the spindle synchronous mode.
Acceleration This parameter is used only with the SPJ2.
rate feed
forward gain
Spindle Set the position error range for output of the
synchronous in-position signal in the spindle synchronous
In-position mode.
width
Spindle Set the excessive error width in the spindle
synchronous synchronous mode.
Excessive
error width
Spindle Set the magnification of current loop gain
synchronous (torque component) in the spindle
Current loop synchronous mode.
gain magnifi-
cation1
Details
Proportional gain
SP178
Speed
SP182 SP017
II - 261
Setting Standard
range setting
0 to 1000 15
(0.1 1/s)
0 to 100 (%) 100
0 to 32767 0
(r/min)
0 to 1000 20
(r/min)
0 to 1000 0
(%)
1 to 2880 16
(1/16°)
1 to 32767 32767
( pulse)
(1 pulse
=0.088°)
1 to 1000 100
(%)