Mitsubishi Electric MELDAS 60 Series Parameter Manual page 106

2.2 Control Parameters
# Item
8101 MACRO SINGLE
8102 COLL. ALM OFF
8103 COLL. CHK OFF
8105 EDIT LOCK B
8106 G46 NO REV-ERR
(For L system only)
8107 R COMPENSATION
8108 R COMP Select
2. Machining Parameters
2.2 Control Parameters
Contents
Select the control of the blocks where the user
macro command continues.
0: Do not stop while macro block continues.
1: Stop every block during signal block
operation.
Select the interference (bite) control to the
workpiece from the tool diameter during tool radius
compensation and nose R compensation.
0: An alarm is output and operation stops when
an interference is judged.
1: Changes the path to avoid interference.
Select the interference (bite) control to the
workpiece from the tool diameter during tool radius
compensation and nose R compensation.
0: Performs interference check.
1: Does not perform interference check.
Select the edit lock for program Nos. 8000 to 9999.
0: Program can be edited.
1: Editing of above program is prohibited.
Select the control for the compensation direction
reversal in G46 (nose R compensation).
0: An alarm is output and operation stops when
the compensation direction is reversed (G41
→ G42‚ G42 → G41).
1: An alarm does not occur when the
compensation direction is reversed‚ and the
current compensation direction is maintained.
0: In arc cutting mode, the machine moves to the
inside because of a delay in servo response to
a command, making the arc smaller than the
command value.
1: In arc cutting mode, the machine
compensates the movement to the inside
because of a delay in servo response to a
command
Specify whether to perform arc radius error
correction over all axes or axis by axis.
0: Perform correction over all axes.
1: Perform correction over axis by axis.
Note: This parameter is effective only when
#8107 R COMPENSATION is 1.
II - 10
Setup range (unit)
0/1
0/1
0/1
0/1
0/1
0/1
0/1