Mitsubishi Electric MELDAS 60 Series Parameter Manual page 331

No. Items
3457 SP257 RPM
(PR)
to to
SP320 BSD
3520
(PR)
3521 SP321 RPML
(PR)
to to
SP384 BSDL
3584
(PR)
8. Spindle Parameters
8.2 MDS-B-SPJ2
Motor This parameter is valid only in the following
constant two conditional cases:
(H coil)
(a) In case that SP034 (SFNC2) bit0=1
and SP034 (SFNC2) bit2=0
Set the motor constants when using a
special motor, not described in the
SP040 (MTYP) explanation and when
not using the coil changeover motor.
(b) In case that SP034 (SFNC2) bit0=1
and SP034 (SFNC2) bit2=1
Set the motor constant of the H coil of
the coil changeover motor.
(Note) It is not allowed for the user to
change the setting.
Motor This parameter is valid only in the following
constant conditional case:
(L coil) (a) In case that SP034 (SFNC2) bit0=1
and SP034 (SFNC2) bit2=1
Set the motor constant of the L coil of
the coil changeover motor.
(Note) It is not allowed for the user to
change the setting.
Details
II - 235
Setting Standard
range setting
0000 to 0000
FFFF
HEX setting
0000 to 0000
FFFF
HEX setting