Mitsubishi Electric MELDAS 60 Series Parameter Manual page 403

# Item
4000 Pinc Machine error
(PR) offset increment
method
<1st axis>
# Item
4001 cmpax Basic axis
4002 drcax Compensation
axis
4003 rdvno Division point
number at
reference point
position
4004 mdvno Division point
number at the
most negative
side
4005 pdvno Division point
number at the
most positive side
4006 sc Compensation
scale factor
4007 spcdv Division interval
9. Machine Error Compensation
9.1 Function Outline
(SETUP PARAM 5. 1/15)
Details
Specify whether to use the incremental
amount method or absolute amount method
when setting the machine error
compensation data.
Details
Specify the basic axis address for machine
error compensation.
1) For pitch error compensation‚ set the
name of the axis to be compensated.
2) For relative position compensation‚ set
the name of the axis to be the base axis.
Set as the "system No. + axis name" when
using the multi-system.
(Example) Z axis for 2nd system: 2Z
Set the compensation axis address for
machine error compensation.
1) For pitch error compensation‚ set the
same axis name as #4001 cmpax.
2) For relative position compensation‚ set
the name of the axis to be actually
compensated.
Set as the "system No. + axis name" when
using the multi-system.
(Example) Z axis for 2nd system: 2Z
Set the compensation data No.
corresponding to the reference point
position. The reference point is actually the
base‚ so there is no compensation No. Set
the number that is decremented by 1.
Set the compensation data No. that is on
the farthest negative side.
Set the compensation data No. that is on
the farthest positive side.
Set the compensation amount's scale.
Set the interval to divide the basic axis.
Each compensation data will be the
compensation amount for each of these
intervals.
II - 307
Setting range
0: Absolute volume
method
1: Incremental
volume method
Setting range
X, Y, Z, U, V, W, A, B,
or C axis address
X, Y, Z, U, V, W, A, B,
or C axis address
4101 to 5124
4101 to 5124
4101 to 5124
0 to 99
1 to 9999999