Mitsubishi Electric MELDAS 60 Series Parameter Manual page 181

# Items
1512 DOORPs Signal input
device 2 for
door interlock
II: for each
system
1513 stapM M code for
synchronous
tap selection
1514 expLinax Exponential
function
interpolation
linear axis
1515 expRotax Exponential
function
interpolation
rotary axis
1516 mill_ax Milling axis
name
1517 mill_C Milling
interpolation
hypothetical
axis name
1518 polm Spindle-
spindle
polygon
Workpiece
spindle No.
1519 pols Spindle-
spindle
polygon
Tool spindle
No.
1520 Tchg34 Additional
(PR) axis tool
compensa-
tion operation
1521 C_min Minimum
turning angle
5. Base Specifications Parameters
Details
Specify the fixed device number (X??) for door
interlock II signal input for each system.
(Specify the same value as that of #1155.)
Related parameter: #1154 pdoor (Door interlock II for
each system)
Select the synchronous tap mode using the
miscellaneous function code of the value set in this
parameter. The M function command can be issued
immediately before the tap command or in the same
block. This function is valid only when 1 is set in
#1272 ext08/bit 1 (Enable/disable M-function
synchronous tap cycle).
Note: Do not use M00, 01 02, 30, 98, and 99.
Set the axis address name for the linear axis used in
exponential function interpolation.
Set the axis address name for the rotary axis used in
exponential function interpolation.
Set the name of the rotary axis used in milling
interpolation. Only one rotary axis can be set.
When there is no E command in issuing the G12.1
command, this parameter will be followed.
Select the hypothetical axis command name for
milling interpolation.
When there is no D command in issuing the G12.1
command, this parameter will be followed.
0: Y axis command
1: Command rotary axis name.
Set the number of the workpiece spindle used in
spindle-spindle polygon machining.
Note: The 1st spindle will be selected when "0" is
set.
Set the number of the tool spindle used in spindle-
spindle polygon machining.
Note: The 2nd spindle will be selected when "0" is
set.
Select whether to carry out the additional axis' tool
compensation function with the 3rd axis or 4th axis.
0: Select 3rd axis.
1: Select 4th axis.
Set the minimum turning angle of the normal line
control axis at the block joint during normal line
control.
II - 85
Setting range (unit)
000 to 100
(hexadecimal)
0 to 99999999
A to Z
A to Z
A to Z
0/1
0 to number of
spindles
0 to number of
spindles
0/1
0.000 to 360.000
(°)