Mitsubishi Electric MELDAS 60 Series Parameter Manual page 88
Cnc
Hide thumbs
Also See for MELDAS 60 Series:
- Maintenance manual (323 pages) ,
- Programming manual (322 pages)
Advertisement
Error No.
P370
NO OPOS MR SPC
The facing turret mirror image
specifications are not provided.
P371
MIRR ILLEGAL
Facing turret mirror image was
commanded to an axis for which external
mirror image or parameter mirror image
is valid.
Facing turret mirror image validating
mirror image for a rotary axis was
commanded.
P380
NO CORNER R/C
A command was issued for corner
chamfering/corner rounding though there
are no such specifications.
P381
NO ARC R/C SPC
Corner chamfering/corner rounding was
specified in the arc interpolation block
although corner chamfering/corner
rounding II is unsupported.
P382
CORNER NO MOVE
The block next to corner chamfering/
corner rounding is not a movement
command.
P383
CORNER SHORT
In the corner chamfering/corner rounding
command‚ the movement distance was
shorter than the value in the corner
chamfering/corner rounding command.
P384
CORNER SHORT
When the corner chamfering/corner
rounding command was input‚ the
movement distance in the following block
was shorter than the length of the corner
chamfering/corner rounding.
P385
G0 G33 IN CONR
A block with corner chamfering/corner
rounding was given during G00 or G33
modal.
P390
NO GEOMETRIC
A geometric command was issued
though there are no geometric
specifications.
P391
NO GEOMETRIC 2
There are no geometric IB specifications.
P392
LES AGL (GEOMT)
The angular difference between the
geometric line and line is 1° or less.
3. Program Error
Details
I - 74
Remedy
• Check the specifications.
• Check the program.
• Check the parameters.
• Check the specifications.
• Remove the corner chamfering/corner
rounding command from the program.
• Check the specifications.
• Replace the block succeeding the corner
chamfering/corner rounding command by
G01 command.
• Make the corner chamfering/corner rounding
less than the movement distance since this
distance is shorter than the corner chamfering/
corner rounding.
• Make the corner chamfering/corner rounding
less than the movement distance since this
distance in the following block is shorter than
the corner chamfering/corner rounding.
• Recheck the program.
• Check the specifications.
• Check the specifications.
• Correct the geometric angle.
Advertisement
