Mitsubishi Electric MELDAS 60 Series Parameter Manual page 350

No. Items
3320 SP120 MPGL
3321 SP121 MPCSH Orientation
3322 SP122 MPCSL Orientation
3323 SP123 MGD0
3324 SP124 MGD1
8. Spindle Parameters
8.3 MDS-B-SP/SPH, MDS-C1-SP/SPH
Orientation Set the compensation magnification of the
position gain orientation position loop gain for the L
L winding winding.
compensa- L winding orientation position loop gain
tion magnifi- = SP001 (or SP002) × SP120/256
cation
When set to "0", will become the same as
SP001 or SP002.
Set the compensation magnification of the
deceleration orientation deceleration rate for the H
rate H winding.
winding
compensa- Orientation deceleration rate for the H
tion magnifi- winding
cation = SP006 × SP121/256
When set to "0", will become the same as
SP006.
Set the compensation magnification of the
deceleration orientation deceleration rate for the L
rate L winding.
winding
compensa- Orientation deceleration rate for the L
tion magnifi- winding
cation = SP006 × SP122/256
When set to "0", will become the same as
SP006.
Magnetic This parameter is used for adjustment of
sensor orientation operation of the magnetic sensor.
output peak Set the output peak value of the magnetic
value sensor.
If a gap between the sensor and the
magnetizing element is small, increase the
value of this parameter. If it is large,
decrease the value of this parameter.
Magnetic This parameter is used for adjustment of
sensor orientation operation of the magnetic sensor.
linear zone Set the linear zone width of the magnetic
width sensor.
If the radius of the mounted magnetizing
element is large, decrease the value of this
parameter. If it is small, increase the value of
this parameter.
Details
II - 254
Setting Standard
range setting
0 to 2560 0
(1/256-fold)
0 to 2560 0
(1/256-fold)
0 to 2560 0
(1/256-fold)
1 to 10000 Standard
magnet-
izing
element:
542
Small
magnet-
izing
element:
500
1 to 10000 Standard
magnet-
izing
element:
768
Small
magnetizin
g element:
440