Mitsubishi Electric MELDAS 60 Series Parameter Manual page 352

No. Items
3332 SP132 PGC3
3333 SP133 PGC4
3334 SP134 VGCP0 C-axis
(PR)
3335 SP135 VGCI0
(PR)
3336 SP136 VGCD0 C-axis
(PR)
3337 SP137 VGCP1 First speed
(PR)
3338 SP138 VGCI1
(PR)
3339 SP139 VGCD1 First speed
(PR)
3340 SP140 VGCP2 Second
(PR)
8. Spindle Parameters
8.3 MDS-B-SP/SPH, MDS-C1-SP/SPH
Third position Set the position loop gain when the third gain
loop gain for is selected for C-axis cutting.
cutting on
C-axis
Stop position Set the position loop gain for stopping when
loop gain for carrying out C-axis cutting.
cutting on
C-axis
Set the speed loop proportional gain in
non-cutting C-axis non-cutting mode.
speed loop
gain
proportional
item
C-axis Set the speed loop integral gain in C-axis
non-cutting
non-cutting mode.
speed loop
gain integral
item
Set the speed loop delay advance gain in
non-cutting C-axis non-cutting mode.
speed loop When this parameter is set to "0", PI control
gain delay is exercised.
advance item
Set the speed loop proportional gain when
loop gain the first gain is selected for C-axis cutting.
proportional
item for
C-axis cutting
First speed Set the speed loop integral gain when the
loop gain first gain is selected for C-axis cutting.
integral item
for cutting on
C-axis
Set the speed loop delay advance gain when
loop gain the first gain is selected for curing on the
delay C-axis.
advance item When this parameter is set to "0", PI control
for cutting on is applied.
C-axis
Set the speed loop proportional gain when
speed loop the second gain is selected for C-axis
gain cutting.
proportional
item for
cutting on
C-axis
Details
II - 256
Setting Standard
range setting
1 to 100 15
(1/s)
1 to 100 15
(1/s)
0 to 5000 63
(1/s)
0 to 5000 60
(0.1 1/s)
0 to 5000 15
(0.1 1/s)
0 to 5000 63
(1/s)
0 to 5000 60
(0.1 1/s)
0 to 5000 15
(0.1 1/s)
0 to 5000 63
(1/s)