Mitsubishi Electric MELDAS 60 Series Parameter Manual page 133

# Items
1095 T0tfof TF output
1096 T_Ltyp Tool life
(for L management
system type
only)
1097 T1digt Tool wear
compensation
number
1-digit
command
1098 Tlno. Tool length
offset number
1099 Treset Cancel tool
wear compen-
sation amount
5. Base Specifications Parameters
Details
Select how to handle TF for T00 command.
0: TF is output.
1: TF is not output
Specify the tool life management type.
Specify the No. of digits in the tool wear
compensation No. in the T command.
0: The 2 high-order digits are the tool No.‚ and
the 2 Iow-order digits are the wear
compensation No.
1: The 3 high-order digits are the tool No.‚ and
the 1 Iow-order digit is the wear
compensation No.
This parameter will be fixed to 0 when tool life
management II is selected.
Specify the No. of digits in the tool length offset No.
in the T command.
0: The 2 or 3 high-order digits are the tool No.
The 2 or 1 Iow-order digits are the tool length
offset and wear compensation Nos.
1: The 2 or 3 high-order digits are the tool No.
and tool length offset Nos.
The 2 or 1 Iow-order digits are the wear
compensation No.
Specify how to handle tool compensation vector
when resetting system.
0: Clear the tool length and wear compensation
vectors when resetting.
1: Save the tool length and wear compensation
vectors when resetting.
When the values are cleared‚ the compensation will
not be applied‚ so the axis will move the
compensation amount in the next compensation
operation.
When the values are saved‚ the compensation will
be applied‚ so the axis will shift the differential
amount of the compensation amount in the next
compensation operation.
II - 37
Setting range (unit)
0/1
1: Life management
type l
2: Life management
type ll
0/1
0/1
0: Clear
1: Save