Mitsubishi Electric MELDAS 60 Series Parameter Manual page 393

No. Items
3417 SP217 TINP
3418 SP218 TODR
(PR)
3419 SP219 IQGT
(PR)
3420 SP220 IDGT
(PR)
3421 SP221 PG2T
3422 SP222 PG3T
3423 SP223 SPDV
3424 SP224 SPDF
8. Spindle Parameters
8.4 MDS-C1-SPM
Synchronized Set the position error range for output of
tapping the in-position during synchronized
in-position tapping.
width
Synchronized Set the excessive error width during
tapping synchronized tapping.
excessive error
width
Synchronized Set the magnification of current loop gain
tapping current (torque component) during synchronized
loop gain tapping.
magnifi-
cation 1
Synchronized Set the magnification of current loop gain
tapping current (excitation component) during
loop gain synchronized tapping.
magnifi-
cation 2
Synchronized Set the second position loop gain when
tapping high-gain control is applied during
position loop synchronized tapping.
gain 2 When this parameter is not used, set to
"0".
Synchronized Set the third position loop gain when
tapping high-gain control is applied during
position loop synchronized tapping.
gain 3 When this parameter is not used, set to
"0".
Speed monitor Set the spindle limit speed in the door
speed open state.
(Invalid when 0 is set.)
If the spindle end speed exceeds this
setting value when the door is open, the
speed monitor error (5E) will occur.
Speed monitor Set the time (continuous) to detect alarms.
time (Detected instantly when 0 is set.)
Details
II - 297
Setting Standard
range setting
1 to 2880 16
(1/16°)
1 to 32767
32767
(pulse)
(1 pulse
=0.088°)
1 to 1000 100
(%)
1 to 1000 100
(%)
0 to 999 0
(1/s)
0 to 999 0
(1/s)
0 to 800 0
(r/min)
0 to 2813 0
(3.5ms)