Mitsubishi Electric MELDAS 60 Series Parameter Manual page 154

# Items
aux06 Servo
(bit2) waveform
display
aux06 Enable/disable
(bit3) setup parameter
lock
aux06 Minimum cut-in
(bit4) amount
selection
aux06 Fixed cycle
(bit5) for compound
lath command
format check
selection
aux06 Zero point
(bit7) return
deceleration
check method
1223 aux07 Rapid traverse
(bit0) inclination
constant
multi-stage
acceleration
and
deceleration
aux07 Deceleration
(bit1) check method 2
5. Base Specifications Parameters
Specify whether to enable the waveform display
function. (Applicable only to M64 D version series)
0: Disable the waveform display function.
1: Enable the waveform display function.
Specify whether to enable the setup parameter lock
function.
0: Disable
1: Enable
Select the minimum cut-in amount command value for
the compound type thread cutting cycle (G76
command) when the minimum cut-in amount (Q) does
not exist in 1st block or 1st block is omitted.
0: The minimum cut-in amount (Q) is "0.".
1: The minimum cut-in amount (Q) is the last
command value.
Select the operation to be made if the 1st block of the
fixed cycle for compound lathe is omitted when the
conventional format is selected (#1265 ext01/bit0 "0").
0: Program error (P33) occurs.
1: Parameter setting value is used.
Set the deceleration check method used during
automatic reference point return.
(Applicable only to M64 D version series)
0: In-position check
1: Commanded deceleration check
Specify whether to enable the rapid traverse
inclination constant multi-stage
acceleration/deceleration function.
(Applicable only to M64 D version series)
0: Disable
1: Enable
Related parameters:
#2064 rapid2 Speed 2
#2065 G0tL2 Time constant 2
#2066 rapid3 Speed 3
#2067 G0tL3 Time constant 3
Select the deceleration check method in G1+G9.
0: Command deceleration check in G1+G9
1: In-position check in G1+G9
The deceleration check is not performed except
G1+G9.
When "#1306 InpsTyp deceleration check
specification type" is set to 1 (Deceleration check
specification type 2), this parameter will be invalid.
II - 58
Details Setting range (unit)
0/1
0/1
0/1
0/1
0/1
0/1
0/1