Mitsubishi Electric MELDAS 60 Series Parameter Manual page 134

# Items
1100 Tmove Tool wear
compen-
sation
1101 Tabsmv Tool wear
compen-
sation method
1102 tlm Manual tool
length
(For L
system measuring
only) system
1103 T_life Validate life
management
1104 T_Com2 Tool
command
method 2
5. Base Specifications Parameters
Details
Specify the period to perform tool length offset and
wear compensation.
0: Compensate when T command is executed.
1: Superimpose and compensate with the
movement command in the block where the T
command is located. If there is no movement
command in the same block‚ compensation
will be executed after the movement
command is superimposed in the next
movement command block.
2: Compensate when the T command is
executed. 1: Superimpose and compensate
a tool length offset with the movement
command in the same block. If there is no
movement command in the same block,
compensation will be executed after the
movement command is superimposed in the
next movement command block.
Specify the type of movement command when
#1100
Tmove is set to 1.
0: Compensate regardless of the movement
command type.
1: Compensate only at the movement
command in the absolute value command.
Specify the measurement method for manual tool
measurement l.
0: Align tool with reference position
1: Input measurement results
Select the usage of the tool life management
function.
Select the command method for when #1103 T_Life
is set to 1.
0: Handle the program tool command as the
group No.
1: Handle the program tool command as the
tool No.
II - 38
Setting range (unit)
0 to 2
0: Compensate
regardless of the
command type.
1: Compensate only
with the absolute
value command.
0: Reference
position method
1: Measured value
input method
0: Do not use.
1: Perform tool life
management
control.
0/1