Mitsubishi Electric MELDAS 60 Series Parameter Manual page 374

No. Items
3243 SP043 TRNG Synchronous
(PR)
3244 SP044 TRAN
(PR) S
3245 SP045 CSNT Dual cushion
3246 SP046 CSN2 Speed
(PR)
3247 SP047 SDTR Speed
(PR)
3248 SP048 SUT
(PR)
3249 SP049 TLM2
3250 SP050 TLM3
3251 SP051 TLM4
3252 SP052 TLM5
3253 SP053 TLM6
3254 SP054 TLM7
3255 SP055 SETM Excessive
(PR)
8. Spindle Parameters
8.4 MDS-C1-SPM
This parameter is used to set the
tapping, spindle synchronous tapping or spindle synchronous
synchronous detector range.
detector range Set "0" for this parameter.
NC communi- Set a frequency of data communication with
cation NC.
frequency
Set the cycle to add the increment values in
timer the dual cushion process.
When this setting value is increased, the dual
cushion will increase, and the changes in the
speed during acceleration/deceleration will
become gradual.
For an acceleration/deceleration time
command dual constant defined in SP019 (CSN1) , this
cushion parameter is used to provide smooth
movement only at the start of
acceleration/deceleration.
As the value of this parameter is smaller, it
moves smoother but the
acceleration/deceleration time becomes
longer.
To make this parameter invalid, set "0".
Set the reset hysteresis width for a speed
detection reset detection set value defined in SP020 (SDTS).
value
Speed reach Set the speed deviation rate with respect to
range the commanded speed for output of the
speed reach signal.
Torque limit 2 Set the torque limit rate for the torque limit
signal 010.
Torque limit 3 Set the torque limit rate for the torque limit
signal 011.
Torque limit 4 Set the torque limit rate for the torque limit
signal 100.
Torque limit 5 Set the torque limit rate for the torque limit
signal 101.
Torque limit 6 Set the torque limit rate for the torque limit
signal 110.
Torque limit 7 Set the torque limit rate for the torque limit
signal 111.
Set the timer value until the excessive speed
speed deviation deviation alarm is output.
timer The value of this parameter should be longer
than the acceleration/deceleration time.
Details
II - 278
Setting Standard
range setting
0 to 7 0
0 to 32767 Standard:
0
Special:
1028
0 to 1000 0
(ms)
0 to 1000 0
0 to 1000 30
(r/min)
0 to 100 15
(%)
1 to 120 20
(%)
1 to 120 30
(%)
1 to 120 40
(%)
1 to 120 50
(%)
1 to 120 60
(%)
1 to 120 70
(%)
0 to 60 (s) 12