Advertisement
Sigma II User's Manual
b. Turn ON the servo ON signal.
Set /S-ON (CN1-40) to 0V. If normal, the servomotor will turn ON and the LED
indicator on the front panel will display as shown above. If an alarm display
appears, take appropriate action as described in 9.2 Troubleshooting.
Note: If there is noise in the reference voltage for speed control, the "-" on the left of the 7-segment LED may flash.
n
Operating Using Reference Input
The operating procedure here depends on the parameter settings (control mode selection at
memory switch Pn000.1). Use the following procedure for operations with speed and posi-
tion control.
Operating Procedure in Speed Control Mode: Set Pn000.1 to 0
Standard speed control setting is described here.
1. Gradually increase the reference speed input (V-REF, CN1-5) voltage. The servomotor
will rotate.
2. Check the following items in Monitor Mode. See 7.1.7 Operation in Monitor Mode.
•
•
•
•
3. If the servomotor rotates at extremely slow speed with 0V specified for the reference
voltage, correct the reference offset value as described in 7.2.3 Automatic Adjustment of
Speed and Torque Reference Offset or 7.2.4 Manual Adjustment of Speed and Torque
Reference Offset.
Display with the servo ON.
Servopack
V-REF
(CN1-5)
SG
(CN1-6)
Un000
Actual motor speed
Un001
Reference speed
Has the reference speed been input?
Is the motor speed as designed?
Does the reference speed coincide with the actual motor speed?
Does the servomotor stop when the speed reference is 0?
Servomotor
Servomotor rotates at a speed proportiona
to the reference voltage.
4-7
Chapter 4: Trial Operation
Advertisement
