Advertisement
Sigma II User's Manual
n
Multi-turn Setup Using the Hand-held Digital Operator
1. Press the DSPL/SET key to select the auxiliary function mode.
2. Select the user function Fn013. Press the Left Arrow
key to select the digit to set, and then press the Up Arrow
key to change the number.
3. Press the DATA/ENTER key. The following display will appear.
4. Press the DSPL/SET key. The display will change as follows, and the absolute
encoder's multi–turn data will be cleared.
5. Press the DATA/ENTER key to return to the auxiliary function mode.
This completes the absolute encoder's multi-turn limit setting operation. Cycle the
power.
n
Multi-turn Setup Using the Built-in Panel Operator
1. Press the DSPL/SET key to select the auxiliary function mode.
2. Press the Up Arrow
3. Press the DATA/SHIFT key. The following display will appear.
Flashes for
1 second.
Flashes for
1 second.
or Down Arrow
Flashes for
1 second.
5-96
Chapter 5: Parameter Settings and Functions
or Right Arrow
or Down Arrow
key to select the parameter Fn013.
Advertisement
