Advertisement
Sigma II User's Manual
T
Changing Function Selection Parameter Settings
Using the Hand-Held Digital Operator
1. Press the DSPL/SET key to select the parameter setting mode.
2. Select the parameter number to be set.
Press the Left Arrow
digit will flash.
Press the Up Arrow
selected in this example.)
3. Press the DATA/ENTER key to display the current data of the parameter selected
in the above step 2.
4. Press the Left Arrow
5. Press the Up Arrow
function setting for the selected digit.
Repeat the above steps 4 and 5 for changing the data as required.
6. Press the DATA/ENTER key to save the data. The display will flash.
or Right Arrow
key to select the digit. The selected
or Down Arrow
key to change the value. (Pn000 is
Digit to be set
or Right Arrow
key to select the digit.
Digit to be set
or Down Arrow
key to select the value defined as a
Digit to be set
7-13
Chapter 7: Using the Digital Operator
Advertisement
