Advertisement
Sigma II User's Manual
Using the Hand-Held Digital Operator
1. Press the DSPL/SET key to select the auxiliary function mode.
2. Select the parameter Fn00C.
Press the Left Arrow
Press the Up Arrow
3. Press the DATA/ENTER key, and the display will be as shown below.
4. Press the DSPL/SET key. Each time the DSPL/SET key is pressed, the monitor
output will toggle between the displays for the two channels shown below.
5. Press the Left Arrow
output data. Pressing the Left Arrow
return to the display shown in the above step 3 or 4.
6. Press the Up Arrow
the analog monitor output.
7. When zero adjustment has been completed for the two channels, press the
DATA/ENTER key to return to the auxiliary function mode display.
This completes the manual zero adjustment of the analog monitor output.
or Right Arrow
key to select the digit.
or Down Arrow
key to change the value.
DSPL/SET Key
Data Display
Displayed
alternately
or Right Arrow
key to display the analog monitor
or Right Arrow
LEFT Cursor Key
(RIGHT Cursor Key)
Data Display
Displayed
alternately
or Down Arrow
key to perform zero adjustment of
Data Setting Change
7-46
Chapter 7: Using the Digital Operator
key again will
Advertisement
