Advertisement
Sigma II User's Manual
key to change the number.
3. Press the DATA/ENTER key. The following display will appear.
4. Pressing the Up Arrow
tinue pressing the Up Arrow
key entry is made, "nO_OP" will flash for one second and the display will return
to the auxiliary function mode. In that case, go back to step 3 above and perform
the operation again.
5. When "PGCL5" is displayed, press the DSPL/SET key. The display will change
as follows, and the absolute encoder's multi–turn data will be cleared.
6. Press the DATA/ENTER key to return to the auxiliary function mode.
This completes the absolute encoder's setup operation. Cycle the power to the servo
amplifier.
n
Setup Using the Built–in Panel Operator
1. Press the DSPL/SET key to select the auxiliary function mode.
key will change the display as shown below. Con-
When an erroneous key entry is made
Up Cursor Key
Up Cursor Key
Flashes for
1 second.
5-94
Chapter 5: Parameter Settings and Functions
key until "PGCL5" is displayed. If an erroneous
Flashes for one second.
Returns to auxiliary function mode.
Advertisement
