Advertisement
Sigma II User's Manual
7.1.4
Basic Mode Selection
The basic mode selection of the digital operator is used for indicating the status of
the servo amplifier in operation and setting a variety of parameters and operation ref-
erences.
The status display, auxiliary function, parameter setting, and monitor modes are the
basic modes. As shown below, the mode is selected in the following order by press-
ing the key.
Hand-held Digital Operator
Press the DSPL/SET Key.
The basic mode changes.
7.1.5
Status Display Mode
In status display mode, bit data and codes are displayed to indicate the status of the
servo amplifier.
T
Selecting Status Display Mode
The digital operator goes into status display mode when the digital operation is
turned ON.
T
Data in Status Display Mode
The screen contents in status display are different for speed, torque, and position
control modes.
Power ON
Status display mode (Refer to
7.1.5 Status Display Mode )
Auxiliary function mode (Refer
to 7.2 Applied Operation )
Parameter Setting Mode (Refer to 7.1.6
Operation in Parameter Setting Mode )
Monitor Mode (Refer to 7.1.7
Operation in Monitor Mode )
7-5
Chapter 7: Using the Digital Operator
Panel Operator
Press the MODE/SET Key.
The basic mode changes.
Advertisement
