Advertisement
Sigma II User's Manual
For motor speed setting procedure, refer to 7.1.6 Operation in Parameter Setting
Mode and 5.3.2 Setting JOG Speed.
Operation procedure using the digital operator is described on the following pages.
Using the Hand-Held Digital Operator
1. Press the DSPL/SET key to select Fn002 in the auxiliary function mode.
2. Press the DATA/ENTER key to select the digital operator operation mode.
Operation is now possible using the digital operator.
3. Press the SVON key to set to the servo ON state (with motor power turned ON).
4. Press the Up Arrow
keeps operating while the key is pressed.
5. Press the DSPL/SET key, and the display will revert to Fn002. This sets to the
servo OFF state (with motor power turned OFF). Alternatively, press the SVON
Key to set to the servo OFF state.
This ends operation under digital operator control.
Panel
YASKAWA
200V
Operator
SERVOPaCK
SGDH-
MODE/SET
DATA/
CHARGE
POWER
L1
C
N
L2
3
Power
1
2
C
L1C
N
1
L2C
B1
B2
U
V
C
W
N
2
or Down Arrow
Motor Forward
Rotation
Chapter 7: Using the Digital Operator
Servo amplifier
Servomotor
key to operate the motor. The motor
Motor Reverse
Rotation
7-25
Advertisement
