Emc-Pg01R -- Pg Card (Resolver) - Delta VFD300C43S-HS User Manual

Chapter 8 Option CardsC2000-HS
8-10 EMC-PG01R
8-10-1 Terminal Descriptions
Set by Pr. 10-00–10-02 and Pr. 10-30 Resolver. (Pr. 10-00=3, Pr. 10-01=1024)
Terminals
R1- R2
PG1
S1, /S3,
S2, /S4,
A2, /A2,
PG2
B2, /B2
AO, /AO,
BO, /BO,
PG OUT
ZO, /ZO
Note 1: Open Collector application, input current 5–15mA to each set then each set needs one pull-up resistor.
5V
12V
24V
PG2 Wiring Diagram
 DOS (Degradation of Signal)：If the amplitude of the sine wave input of the S1-/S3/ S2-/S4 is lower than or
higher than the encoder IC's specification, a red light is on. The possible reasons are the following.
1. The turns ratio of the resolver encoder is not 1:0.5 which makes the sine wave input of the
S1-/S3/S2-/S4 not equal to 3.5±0.175Vrms.
2. While motor is running, motor creates common mode noise which makes accumulated voltage to be
more than 3.5±0.175Vrms
 LOT (Loss of Tracking): Compare the angle of S1-/S3/S2-/S4 sine wave input to the R1-R2 cosine wave. If
their difference is more than 5 degree, a red light is on. The following are the possible reasons:
1. The output frequency of the PG card is incorrect.
2. The specification of Resolver's encoder is not 10kHz
3. The motor creates common mode noise while it is running. That causes a big difference, while the
motor is rotating, between main winding's cosine wave angle and the sine wave angle of second and
third windings.
-- PG card (Resolver)
Resolver Output Power
7Vrms, 10kHz
Resolver Input Signal (S2, /S4=Sin; S1, /S3=Cos)
3.5±0.175Vrms, 10kHz
Pulse Input signal (Line Driver or Open Collector)
Open Collector Input Voltage: +5– +24V (Note1)
It can be 1-phase or 2-phase input.
Max. output frequency: 300kHz
PG Card Output signals. It has division frequency function: 1–255
times
Max. output voltage for Line driver: 5V
Max. output current: 15mA
,
Max. output frequency: 300kHz
SG
SG is the GND of PG card. It is also the GND of position machine or
PLC to make the output signal to be the common pivot point.
Recommended pull-up resistor: above 100–220, 1/2W
Recommended pull-up resistor: above 510–1.35k, 1/2W
Recommended pull-up resistor: above 1.8k–3.3k, 1/2W
Descriptions
DC
8-24