Delta VFD300C43S-HS User Manual page 463

13 Application Parameters by Industry
Application Selection
Settings
 Note: after you select the macro, some of the default values adjust automatically according to
the application selection.
 Group setting 02: Compressor (IM)
The following table lists the relevant compressor application parameters.
Pr.
00-11 Speed control mode
00-16 Load selection
00-17 Carrier frequency
Master frequency command source (AUTO)
00-20
/ Source selection of the PID target
00-21 Operation command source (AUTO)
00-22 Stop method
00-23 Control of motor direction
01-00 Maximum operation frequency
01-01 Output frequency of motor 1
01-02 Output voltage of motor 1
01-03 Mid-point frequency 1 of motor 1
01-04 Mid-point voltage 1 of motor 1
01-05 Mid-point frequency 2 of motor 1
01-06 Mid-point voltage 2 of motor 1
01-07 Minimum output frequency of motor 1
01-08 Minimum output voltage of motor 1
01-11 Output frequency lower limit
01-12 Acceleration time 1
01-13 Deceleration time 1
03-00 Analog input selection (AVI)
03-01 Analog input selection (ACI)
05-01 Full-load current for induction motor 1 (A)
05-03 Rated speed for induction motor 1 (rpm)
05-04 Number of poles for induction motor 1
0: Disabled
1: User-defined Parameter
2: Compressor (IM)
3: Fan
4: Pump
10: Air Handling Unit, AHU
Explanation
Chapter 12 Description of Parameter SettingsC2000-HS
 This parameter can be set during operation.
0 (V/F control)
0 (Normal load)
Default setting
2 (External analog input)
1 (External terminals)
0 (Ramp to stop)
1 (Disable reverse)
Default setting
Default setting
Default setting
Default setting
Default setting
Default setting
Default setting
Default setting
Default setting
20 (Hz)
20 (s)
20 (s)
0 (No function)
1 (Frequency command)
Default setting
Default setting
Default setting
12.1-13-1
Default: 0
Settings