Delta VFD300C43S-HS User Manual page 428

Chapter 12 Description of Parameter SettingsC2000-HS
Modbus
R/W
address
2101H
2102H
2103H
2104H
2105H
2106H
2107H
2108H
2109H
210AH
210BH
210CH
210DH
210EH
210FH
2116H
211BH
211FH
Status monitor read only (22xx)
Modbus
address
2200H
2201H
2202H
2203H
2204H
AC motor drive operation status
bit1–0 00B: Drive stops
01B: Drive decelerating
10B: Drive standby
11B: Drive operating
bit2
1：JOG Command
Operation Direction
bit4–3 00B: FWD run
01B: From REV run to FWD run
10B: From FWD run to REV run
R
11B: REV run
bit8 1: Master frequency controlled by communication interface
bit9 1: Master frequency controlled by analog/external signal
bit10 1: Operation command controlled by communication interface
bit11 1: Parameter locked
bit12 1: Enable to copy parameters from keypad
bit15–13 Reserved
R Frequency command (XXX.XX Hz)
R Output frequency (XXX.XX Hz)
Output current (XX.XX A). When current is higher than 655.35, it shifts the
R
decimal as (XXX.X A). The decimal can refer to High byte of 211F.
R DC BUS Voltage (XXX.X V)
R Output voltage (XXX.X V)
R Current step number of multi-step speed operation
R Reserved
R Counter value
R Power factor angle (XXX.X)
R Output torque (XXX.X %)
R Actual motor speed (XXXXX rpm)
R Number of PG feedback pulses (0–65535)
R Number of PG2 pulse commands (0–65535)
R Power output (X.XXX kW)
R Multi-function display (Pr. 00-04)
Maximum Operation Frequency (Pr. 01-00) or Maximum User-defined Value
(Pr. 00-26)
When Pr. 00-26 is 0, this value is equal to Pr. 01-00 setting
R When Pr. 00-26 is not 0, and the command source is keypad, this value =
Pr. 00-24 * Pr. 00-26 / Pr. 01-00
When Pr. 00-26 is not 0, and the command source is 485, this value = Pr.
09-10 * Pr. 00-26 / Pr. 01-00
R High byte: decimal of current value (display)
RW
Display output current (A). When current is higher than 655.35, it shifts the
R
decimal as (XXX.X A). The decimal can refer to High byte of 211F.
R Display counter value (c)
R Actual output frequency (XXXXX Hz)
R DC BUS voltage (XXX.X V)
R Output voltage (XXX.X V)
Function
Function
12.1-09-9