Delta VFD300C43S-HS User Manual page 313

Settings Functions
9 Drive is ready
10 Low voltage warning (Lv)
11 Malfunction indication
Mechanical brake
12
release (Pr. 02-32)
Over-heat warning (Pr.
13
06-15)
Software brake signal
14
indication
15 PID feedback error
16 Slip Error (oSL)
Count value reached,
17 does not return to 0 (Pr.
02-20)
Counter value reached,
18
returns to 0 (Pr. 02-19)
External interrupt B.B.
19
input (Base Block)
20 Warning output
21 Over-voltage
Over-current stall
22
prevention
Over-voltage stall
23
prevention
Operation mode
24
indication
25 Forward command
26 Reverse command
Output when Current ≥
27
Pr. 02-33
Output when Current <
28
Pr. 02-33
Output when frequency
29
≥ Pr. 02-34
Output when Frequency
30
< Pr. 02-34
Chapter 12 Description of Parameter SettingsC2000-HS
Active when the drive is ON with no error detected.
Active when the DC BUS voltage is too low (refer to Pr. 06-00 Low
Voltage Level).
Active when fault occurs (except Lv stop).
Active when the drive runs after the set delayed time for Pr. 02-32.
This function must use with DC brake function.
Active when IGBT or heat sink overheats; to prevent the drive
from shutting down due to over-heating (refer to Pr. 06-15).
Active when the soft brake function is ON (refer to Pr. 07-00) .
Active when the PID feedback signal error is detected.
Active when the slip error is detected.
When the drive executes external counter, this contact is active if
the count value is equal to the setting value for Pr. 02-20.
This contact is not active when the setting value for Pr. 02-20 > Pr.
02-19.
When the drive executes the external counter, this contact is
active if the count value is equal to the setting value for Pr. 02-19.
Active when external interrupt (B.B.) stop output occurs in the
drive.
Active when a warning is detected.
Active when over-voltage is detected.
Active when over-current stall prevention is detected.
Active when over-voltage stall prevention is detected.
Active when the operation command is controlled by external
terminal. (Pr. 00-21≠0)
Active when the operation direction is forward.
Active when the operation direction is reverse.
Active when the current is ≥ Pr. 02-33.
Active when the current is < Pr. 02-33
Active when the frequency is ≥ Pr. 02-34.
(Actual output H ≥ Pr.02-34)
Active when the frequency is < Pr. 02-34.
(Actual output H < Pr.02-34)
12.1-02-15
Descriptions