Delta VFD300C43S-HS User Manual page 259

Pr. Parameter Name
Detection time of encoder /
 10-14
speed observer slip
Encoder / speed observer stall
 10-15
and slip error action
 10-16 Pulse input type setting
 10-17 Electrical gear A
 10-18 Electrical gear B
 10-19 Positioning for encoder position
Error range for encoder position
 10-20
reached
 10-21 Filter time (PG2)
 10-24 FOC & TQC function control
FOC bandwidth for speed
 10-25
observer
 10-26 FOC minimum stator frequency
FOC low-pass filter time
 10-27
constant
FOC gain for excitation current
 10-28
rise time
 10-29 Top limit of frequency deviation
Chapter 11 Summary of Parameter SettingsC2000-HS
Setting Range
0.0–10.0 sec.
0: Warn and continue operation
1: Warn and ramp to stop
2: Warn and coast to stop
0: Disable
1: Phases A and B are pulse inputs, forward direction if
A-phase leads B-phase by 90 degrees
2: Phases A and B are pulse inputs, forward direction if
B-phase leads A-phase by 90 degrees
3: Phase A is a pulse input and phase B is a direction
input (L = reverse direction, H = forward direction).
4: Phase A is a pulse input and phase B is a direction
input. (L = forward direction, H = reverse direction).
5: Single-phase pulse input (MI8)
1–65535
1–65535
-32767–2400
0–65535 pulses
0.000–65.535 sec.
bit0: ASR control at sensorless torque (0: use PI as
ASR; 1: use P as ASR)
bit11: Activate DC braking when executing zero torque
command (0: ON; 1: OFF)
bit12: FOC Sensorless mode, cross zero means speed
goes from negative to positive or reverse
direction (0: determined by stator frequency; 1:
determined by speed command)
bit15: Direction control at open loop status (0: Switch
ON direction control; 1: Switch OFF direction
control)
20.0–100.0 Hz
0.0–10.0 %fN
1–1000 ms
33–100 %Tr
0.0–200.0 Hz
11-43
Default
0.5
2
0
100
100
0
10
0.100
0
40.0
2.0
50
100
20.0