Delta VFD300C43S-HS User Manual page 163

Environment
Noise immunity
Operation/storage
Vibration/shock
immunity
8-14-4 Installation
Connecting CMC-EIP01 to Network
1. Turn off power to the AC motor drive.
2. Open the cover of the AC motor drive.
3. Connect a CAT-5e network cable to the RJ45 port on the
CMC-EIP01 (See Figure 2).
RJ45 PIN Definition
PIN Signal
1 Tx+
2 Tx-
3 Rx+
4 --
8-14-5 Communication Parameters for VFD-C2000-HS Connected to Ethernet
When the VFD-C2000-HS is connected to an Ethernet network, set up the communication
parameters for it according to the table below. The Ethernet master is only able to read/write the
frequency word and control word of VFD-C2000-HS after the communication parameters are set.
Parameter
Pr. 00-20
Pr. 00-21
Pr. 09-30
Pr. 09-75
Pr. 09-76
Pr. 09-77
Pr. 09-78
Pr. 09-79
ESD (IEC 61800-5-1, IEC 61000-4-2)
EFT (IEC 61800-5-1, IEC 61000-4-4)
Surge Test (IEC 61800-5-1, IEC 61000-4-5)
Conducted Susceptibility Test (IEC 61800-5-1, IEC 61000-4-6)
Operation: -10°C–50°C (temperature), 90% (humidity)
Storage: -25°C–70°C (temperature), 95% (humidity)
International standards: IEC 61800-5-1, IEC 60068-2-6 / IEC 61800-5-1, IEC
60068-2-27
Definition PIN
Positive pole for
data transmission
Negative pole for
data transmission
Positive pole for
data receiving
N/C
Function
Source of frequency
command setting
Source of operation
command setting
Decoding method for
communication
IP setting
IP address -1
IP address -2
IP address -3
IP address -4
Signal Definition
5 -- N/C
Negative pole for
6 Rx-
data receiving
7 -- N/C
8 -- N/C
Set value (Dec)
The frequency command is controlled by
8
communication card.
The operation command is controlled by
5
communication card.
The decoding method for Delta AC motor
0
drive
0 Static IP(0) / Dynamic distribution IP(1)
192 IP address 192.168.1.5
168 IP address 192.168.1.5
1 IP address 192.168.1.5
5 IP address 192.168.1.5
8-35
Chapter 8 Option CardsC2000-HS
[Figure 2]
Explanation