Delta VFD300C43S-HS User Manual page 430

Chapter 12 Description of Parameter SettingsC2000-HS
Modbus
address
2227H
2228H
2229H
222AH
222BH
222CH
222DH
222EH
222FH
2230H
2231H
Remote IO (26xx)
Modbus
address
2601H
2602H
2603H–
2640H
2641H
2642H–
2660H
2661H
2662H
2663H
2664H–
266AH
266BH
266CH
266DH–
26A0H
26A1H
26A2H
26A3H–
26AAH
26ABH
26ACH
5. Exception response:
When the drive is using the communication connection, if an error occurs, the drive responds
to the error code and sets the highest bit (bit 7) of code to 1 (function code AND 80H) then
responds to the control system to signal that an error occurred.
If the keypad displays "CE-XX" as a warning message, "XX" is the error code at that time.
Refer to the table of error codes for communication error for reference.
RW
bit5 0b: No alarm
1b: Alarm
R Drive's estimated output torque (positive or negative direction) (XXXX Nt-m)
R Torque command (XXX.X %)
R kWh display (XXXX.X)
R PG2 pulse input in Low Word
R PG2 pulse input in High Word
R Motor actual position in Low Word
R Motor actual position in High Word
R PID reference (XXX.XX %)
R PID offset (XXX.XX %)
R PID output frequency (XXX.XX Hz)
R Hardware ID
RW
R Each bit corresponds to different terminal input contact
R Each bit corresponds to different terminal input contact
R Reserved
RW Each bit corresponds to different terminal output contact
R Reserved
R AVI proportional value
R ACI proportional value
R AUI proportional value
R Reserved
R Expansion card AI10, 0.0–100.0 % (EMC-A22A)
R Expansion card AI11, 0.0–100.0 % (EMC-A22A)
R Reserved
RW AFM1 output proportional value
RW AFM2 output proportional value
R Reserved
RW Expansion card AO10, 0.0–100.0 % (EMC-A22A)
RW Expansion card AO11, 0.0–100.0 % (EMC-A22A)
Function
Function
12.1-09-11