Delta VFD300C43S-HS User Manual page 311

Chapter 12 Description of Parameter SettingsC2000-HS
2: Operation speed reached
3: Desired frequency reached 1 (Pr. 02-22)
4: Desired frequency reached 2 (Pr. 02-24)
5: Zero speed (Frequency command)
6: Zero speed including STOP (Frequency command)
7: Over-torque 1 (Pr. 06-06–06-08)
8: Over-torque 2 (Pr. 06-09–06-11)
9: Drive is ready
10: Low voltage warning (Lv) (Pr. 06-00)
11: Malfunction indication
12: Mechanical brake release (Pr. 02-32)
13: Over-heat warning (Pr. 06-15)
14: Software brake signal indication (Pr. 07-00)
15: PID feedback error (Pr. 08-13, Pr. 08-14)
16: Slip error (oSL)
17: Count value reached, does not return to 0 (Pr. 02-20)
18: Count value reached, returns to 0 (Pr. 02-19)
19: External interrupt B.B. input (Base Block)
20: Warning output
21: Over-voltage
22: Over-current stall prevention
23: Over-voltage stall prevention
24: Operation mode
25: Forward command
26: Reverse command
27: Output when current ≥ Pr. 02-33
28: Output when current < Pr. 02-33
29: Output when frequency ≥ Pr. 02-34
30: Output when frequency < Pr. 02-34
31: Y-connection for the motor coil
32: △ -connection for the motor coil
33: Zero speed (actual output frequency)
34: Zero speed including stop (actual output frequency)
35: Error output selection 1 (Pr. 06-23)
36: Error output selection 2 (Pr. 06-24)
37: Error output selection 3 (Pr. 06-25)
38: Error output selection 4 (Pr. 06-26)
39: Position reached (Pr. 10-19)
40: Speed reached (including stop)
41: Multi-position reached
42: Crane function
43: Actual motor speed higher than Pr. 02-47
12.1-02-13