Delta VFD300C43S-HS User Manual page 314

Chapter 12 Description of Parameter SettingsC2000-HS
Settings Functions
Y-connection for the
31
Motor coil
△ -connection for the
32
Motor coil
Zero speed (actual
33
output frequency)
Zero speed includes
34 stop (actual output
frequency)
Error output selection 1
35
(Pr. 06-23)
Error output selection 2
36
(Pr. 06-24)
Error Output Selection 3
37
(Pr. 06-25)
Error output selection 4
38
(Pr. 06-26)
Position reached
39
(Pr. 10-19)
Speed reached
40
(including stop)
41 Multi-position reached
Active when Pr. 05-24=1, the frequency output is lower than Pr.
05-23 minus 2Hz, and the time is longer than Pr. 05-25.
Active when Pr. 05-24=1, the frequency output is higher than Pr.
05-23 plus 2Hz, and the time is longer than Pr. 05-25.
Active when the actual output frequency is 0. (the drive is in RUN
mode)
Active when the actual output frequency is 0 or Stopped.
Active when Pr. 06-23 is ON.
Active when Pr. 06-24 is ON.
Active when Pr. 06-25 is ON.
Active when Pr. 06-26 is ON.
Active when the PG position control point reaches Pr. 10-19.
Active when the output frequency reaches the setting frequency or
stopped.
You can set any three multi-function input terminals to 41 (as table
below). These three terminals output according to the completed
position of multi-point positioning.
For example: set Pr. 02-36–02-38 to 41, the second point of the
multi-point positioning is completed. In this case, RY2 is ON, RY1
and MO1 are OFF (010). bit0 is RA and so on.
MO2
Pr.02-17=41
Pr. 04-16 0
Pr. 04-18 0
Pr. 04-20 0
Pr. 04-22 0
Pr. 04-24 0
Pr. 04-26 0
Pr. 04-28 0
Pr. 04-30 1
Pr. 04-32 1
Pr. 04-34 1
Pr. 04-36 1
Pr. 04-38 1
Pr. 04-40 1
Pr. 04-42 1
Pr. 04-44 1
12.1-02-16
Descriptions
MO1 RY2
Pr.02-16=41 Pr.02-14=41
0 0
0 1
0 1
1 0
1 0
1 1
1 1
0 0
0 0
0 1
0 1
1 0
1 0
1 1
1 1
RY1
Pr.02-13=41
1
0
1
0
1
0
1
0
1
0
1
0
1
0
1