Delta VFD300C43S-HS User Manual page 207

4. Scale Setting : On the Tool Bar, click on
Property Window on the right hand side of your computer screen.
a. Scale Position: Click on the drop down list to choose which position that you need to place a scale.
b. Scale Side: Click on the drop down list to choose if you want to number your scale from smaller
number to bigger number or from big to small. Click OK to accept this setting or click Cancel to
abort.
c. Font Setting: Click on the drop down list to choose the Font setting that you need then click OK to
accept the setting or click Cancel to abort.
d. Value Length: Click on the drop down to choose 16 bits or 32 bits. Then click OK to accept the
setting or click Cancel to abort.
e. Main Scale & Sub Scale: In order to divide the whole scale into equal parts, key in the numbers of
your choices for main scale and sub scale.
f. Maximum value & Minimum Value are the numbers on the two ends of a scale. They can be
negative numbers. But the values allowed to be input are limited by the length of value. For
example, when the length of value is set to be hexadecimal, the maximum and the minimum value
cannot be input as -4000.
Follow the Scale setting mentioned above; you will have a scale as shown below.
5. Bar Graph setting
a. Related Device: Choose the VFD Communication Port that you need.
b. Direction Setting: Click on the drop down menu to choose one of the following directions: From
Bottom to Top, From Top to Bottom, From Left to Right or From Right to Left.
c. Maximum Value & Minimum Value: They define the range covered by the maximum value and
minimum value. If a value is smaller than or equal to the minimum value, then the bar graph will be
blank. If a value is bigger or equal to the maximum value, then the bar graph will be full. If a value is
between minimum and maximum value, then the bar graph will be filled proportionally.
:
10-27
Chapter 10 Digital KeypadC2000-HS
for Scale Setting. You can also edit Scale Setting in the